Daily Maintenance
Arc 127 End-of-Day Maintenance
- 0:00Power Down and Air Release
- 0:32Clean Blade and Cutting Area
Written steps
2
- Turn off the main power switch on the machine.
- Unplug the main power cord.
- Turn off the air compressor by pressing down its main power switch.
- Close the air outlet valve on the compressor.
- Unplug the compressor power cord.
- Pull the connector switch backward.
- Remove the air tube to release air inside the machine and prevent water buildup and potential damage.
- Loosen the screw holding the blade holder.
- Remove any scraps or debris around the blade and blade holder.
- Clean the blade and blade holder using alcohol.
- Vacuum the cutting platform to remove debris.
- Dispose of waste film from the collector basket.
- Cover the cutter to protect it from dust and debris.
Weekly Maintenance
Arc 127 Weekly Maintenance
- 0:00Drain Oil Water Filter
- 0:47Drain Air Compressor
Written steps
2
- Go to the take-up reel side of the machine.
- Remove the machine cover to expose the internal components.
- Locate the oil water filter on the right side of the machine.
- Inspect the clear cylinder under the filter for water buildup.
- Pull the drain ring downward using a paper towel to remove excess water.
- Confirm the water has been fully drained.
- Perform this procedure weekly.
- Locate the air compressor underneath the machine.
- Find the air receiver drain plug on the compressor.
- Unscrew the drain plug to release any water buildup.
- Allow all water to drain completely.
- Tighten the drain plug back into position once draining is complete.
Stuck on a step?
Your authorized dealer and our factory support team answer on Discord — the fastest route to a person who knows this machine.
Get support
