Prestige L2 & XL2Customer login

How to change the cap on the Prestige L2 & XL2 | DTF Station

Every step links to its own moment in the video, so you never hunt for the right part again.

  • 5 steps
  • 16 instructions
  • 1 video
  • Updated 2026-04-20

How to Replace the Capping Station Cap — Prestige L2 & XL2

  1. 0:00Overview & Required Tools
  2. 0:08Step 1 – Power Down and Access the Carriage
  3. 0:22Step 2 – Remove the Old Capping Station Cap
  4. 0:46Step 3 – Install the New Cap
  5. 1:22Step 4 – Verification
Written steps 5

Overview & Required Tools

Watch this part0:00

TOOLS NEEDED

  • Magnetic screwdriver
  • Replacement capping station cap

Step 1 – Power Down and Access the Carriage

Watch this part0:08
  1. Turn the printer completely OFF.
  2. Open the printer cover and front panel.
  3. Locate the carriage release knob.
  4. Loosen the knob to disengage the printer carriage.
  5. Manually move the carriage toward the center of the printer.

Step 2 – Remove the Old Capping Station Cap

Watch this part0:22
  1. With the capping station fully exposed, locate the mounting screws on the cap.
  2. Use a magnetic screwdriver to remove the screws.
  3. Carefully pull the cap straight upward.
  4. Disconnect the ink tubes attached to the cap.

Step 3 – Install the New Cap

Watch this part0:46
  1. Take the new capping station cap.
  2. Reconnect the ink tubes firmly to the new cap.
  3. Place the cap back into the capping station housing.
  4. Ensure the cap sits completely flush in its slot.
  5. Reinstall and tighten the mounting screws.

Step 4 – Verification

Watch this part1:22
  1. Turn the printer back ON.
  2. Perform a nozzle check from the control panel. RESULT CHECK
  • If the nozzle check shows perfect nozzles:
  • The new capping station cap has been installed successfully.
  • If issues persist:
  • Recheck tube connections and cap seating.

Stuck on a step?

Your authorized dealer and our factory support team answer on Discord — the fastest route to a person who knows this machine.

Get support

Need a person to answer?

Message the DTF Station team in Vietnam on Zalo — Mon–Sat, 8:00–17:00, usually answered the same day. If you need ink, film or powder, ask in the same message.

Chat on Zalo Ask about supplies See equipment