How to Perform Quick Test and Alignment Print Test

1. This guide explains how to perform a **Quick Print Test** when requested by support.
2. These steps are used when support asks you to print a test and send in the printed film for review.

1. Open **DigiRIP**.
2. Click **Devices** in the top menu.
3. Select **Quick Print Test**.
4. The **CADlink Print Test Page** will appear.
5. This is the test page support typically needs.

based on your film orientation.

• You may resize the test page if:
• You are using smaller film.
• Otherwise, keep the **original size** if possible.
• You may rotate the image:
• Horizontal
• Vertical

1. Once adjustments are complete, click **Print**.
2. Print the test page onto film.
3. Send the printed film to support as requested.

1. In some cases, support may ask for a different test.
2. Go to **Devices**.
3. Select **Print Test Page**.
4. This menu provides additional test images.

1. One commonly used alternate test is the **Alignment** test.
2. This is used when: Head spacing adjustments have already been applied
3. Load the alignment image.
4. Rotate if needed, or leave it in the default orientation.
5. Print the test page.
6. Send the printed film to support.

• White ink is still peeking out

• Support will analyze the printed test.
• You may be guided over the phone to:
• Manually adjust **head spacing**
• Fine-tune alignment settings

This completes the process for performing and submitting print tests in DigiRIP.